Jameco-electronics Superpro Series Manual do Utilizador

The content and copyrights of the attached material are the property of its owner.Distributed by:www.Jameco.com ✦ 1-800-831-4242

selection of the device to read from. Click on Run from the main screen, which will pop up the Function screen. Click on the Read function, which co

Figure 8 Data type 2.1.2 Save This selection will save the current data in the buffer to d

Figure 9. Edit Buffer Locate The function is convenient for locating a set of data for editing. In the Locate

Swap MSB and LSB byte order for the specified word width in the address range.

This opens the Vector Buffer Edit window. If a test vector table is included in the JEDEC file, the software will load the test vector table to the

Figure 15. Run Program The function writes the data from the buffer into the chip. The Verify function i

Verify The function compares the content of the buffer to that of the chip. If there is any discrepancy, verify failure message and the address whe

Chip End Input an address for the chip where you would like a selected function of downloading or uploading to end. This is normally set to the end

Edit box. When the highlighted cursor is placed over a name of the manufacturer, names of the devices for the manufacturer selected will be displaye

The Word Format window allows you to specify the data format loaded into the buffer. The default setting is Byte format. Word or Double Word format

SUPERPRO® series Universal Programmers For Windows 95/98/NT/2000 User’s Guide XELTEK Jameco Part Nu

Figure 18. Word Format 2.4. Test: <Alt-T> The SUPERPROs can test logic ICs and RAM devices, as well as perform vector testing on P

L: Output Logic Low (Vol) C: Clock pin 1: Input Logic High (Vih) 0: Input Logic Low (Vil) 2.4.2 Edit Pattern This selection is used for edi

deleted and you will return to the main menu. Make sure you have made the correct selection. The only way to retrieve a deleted test pattern is to

Option: Check Insertion Test if you want the programmer to do an insertion test before any operation on the device. Check Beeper if you want the pr

e) Start programming. Figure 21 .Auto Increment 2.5.3 Load config file Operational Configuration is created automaticall

XELTEK software has been designed to require a minimum of technical support. The program comes with a comprehensive User's Guide. If you cann

Modify, copy, or transfer the User's Guide, other documentation or any copy. Reverse engineer, decompile, or disassemble any program module or

3.2.1 Invalid File Type: An input file with wrong format is selected. Please select right format for the input file. 3.2.2 Init Programmer Error(P

COPYRIGHTS Software Copyrights 1997-2000 XELTEK User's Guide Copyrights 1997-2000 XELT

Contents 1. General Description 1.1 Introduction 1.1.1 What is Superpro? 1.1.2 Manual Organization 1.1.3 Manual C

2.3.3 Select 2.3.4 Word Format 2.4 Test: <Alt-T> 2.4.1 New Pattern 2.4.2 Edit Pattern 2.4.3 Delete Pattern 2.4.

1.1 INTRODUCTION 1.1.1 What is Superpro? The SUPERPRO is a family of affordable, reliable, and fast universal IC device programmers. They are d

Up arrow key = <Up arrow> Down arrow key = <Down arrow> Unless stated otherwise, keystrokes are not case-sensitive. e.g.: Both 'A

switch and observe the power LED coming on bright. Please be sure not to insert any chip onto the programmer socket at this time. 1.2.3 Running t

1.2.5 Device Insertion For chips in DIP package Follow the reference diagram next to the socket. Chips are always inserted at the bottom line of t